Is your toilet making strange sounds? How about gurgling and bubbling? Does it seem like it is constantly running? A toilet shouldn’t be making sounds and the water line in the bowl should be nice and low. Plus, the flush should be strong. If anything is wrong, you need to get to the bottom of the issue right away, because there could be something seriously wrong with your toilet. The last thing you want is to let a small problem become a big problem. Not only could you have a major mess on your hands, but the problem could become expensive to fix, especially if you need to replace major parts. Here is how to troubleshoot common toilet problems.
- Try jiggling the handle. If your toilet is making a sound like it is still running, you want to try jiggling the handle. Sometimes, the chain doesn’t lift the inlet valve correctly and the water keeps pouring in. Jiggling the handle will release the inlet valve and it will stop the water from trickling in. It will also stop the running sound, which can be a relief.
- Use a plunger to remove clogs. If you have a major clog, you want to use a plunger to dislodge whatever is causing the clog. Typically, the culprit behind clogged toilets is toilet paper. A plunger will create a suction chamber that will hopefully pull the clog out of the pipe. If a plunger doesn’t work, you may want to call a professional plumbing service, like Northeast Plumbing. A plumber will come through with rooter tools and other instruments to fix the clog.
- Use a wire to clear debris for a stronger flush. If you are experiencing a slow flush, you may have debris in the flush holes underneath the toilet rim. You can usually use a coat hanger to remove the debris. Just fashion the coat hanger into a hook, lift the flaps on the flush holes and poke around. You may need to close the flap and then flush a few times to make sure the debris is totally gone. After a few pokes and flushes, the debris should wash away and your flush should be strong again.
- Tighten seals. Tightening seals is also incredibly important, because they can loosen over time. This can cause water to come up through the floor. If you let your seals become too loose, it can cause the toilet to shift and become damaged, which can be an expensive fix. When it comes down to it, you can use a wrench to tighten the seals.
- Adjust the float. The float is basically a flap that covers the inlet hole in the tank. If you are noticing that the toilet is filling up with too much water or is not flushing at all, it may be that the float needs to be adjusted. If the float is damaged, you will want to repair it. In the end, replacing a damaged float is an inexpensive fix that will bring your toilet back to perfect working condition.